Mars battery disassembly operation

一、Battery disassembly operation

① When the robot is turned off, put the robot down and put some foam or carpet under it.

② Using an M4 Allen wrench, remove the four screws around the battery under the robot chassis.

③ Unplug the two power cords of the battery separately. Pay special attention: wrap the two cords with insulating tape and do not touch them to prevent short circuits.

二、Battery installation operation

① When the robot is turned off, put the robot down and put some foam or carpet under it.

② Connect the two power cords of the battery according to the corresponding harness color. Special attention: The two wire ends must not contact each other to prevent short circuits.

③ Use an M4 Allen wrench to install the battery holder in place and lock the four screws. Special attention: When placing the power cord inward, do not press the cord to prevent short circuits.

三、Power on

① Press the power button once, and the button is pressed down. Is open.

② Press the ON key once, and the robot will turn on, and the screen and light strip will light up. Press and hold the ON key for 10 seconds before shutting down.

③ As shown in the following figure, part 1 is the power supply and part 2 is the switch.